Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have an MPLS network using Cisco routers.PE routers mostly IOS-XE2 RR IOS-XR running full table from upstream in a VRF.The RR also run my eBGP peerings to my upstreams.The Internet routing table is in a VRF.The RR send a default route to all PE's...
HiI have an small MPLS network with around 30 x ASR920, no P, all routers are PE. 2 of them are running as RR. All works fine.My Public Internet is running in a VRF, so upstream just peers to a 920 and it sends prefixes to the RR that sends them out...
Hi All
I have created the following config on a 819HG.
When i from the router ping a host on the Internet it gives me 40-50ms and no packet loss.
When i from a host behind (NAT) the router i get 50% packet loss.
My config that fails is in the file....
Hi HeroldMakes sense.. I will try it out, as soon as i have a window. But it sounds 100% like you nailed it.I will give a feedback when i have done the test.Thanks a lot /James
RR is RR for many VRF's incl. the INET where all the public adresses are.I wan't eBGP from CE to RR. But CE is connected to PE to gain access to the INET VRF. But Peering is from CE (Not MPLS aware) to RR.Route target on RR:vrf INETaddress-family ipv...
Hi allJust has this problem at a customer site.Until i checked the logs from this switch it gave me the info i needed.The gateway on the 2 vlans are a firewall/router and typical we use a subinterface (To be smart )BUT the router is a mac saving so...
Hi, Thnaks for your post In a reguler vrf i have rd MY-ASN:VRF# (Like 3030:500)Then for my own routes (Orign from my AS and from my costumers) i will give them ASN:VRF#1 (Like 3030:500) and for all the routes in the same VRF from the Internet i wil...
