Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi We are using ISE 2.4 and are using enforcement (closed) mode at our main office. It is working fine on all our switch stacks (3850 version 16.6.6). I take the same configuration and apply it to another location using the same ISE appliance, same s...
Hi All I have currently configured this on each switch port:authentication event fail action next-methodauthentication event server dead action authorizeauthentication event server dead action authorize voiceauthentication event server alive action r...
Hello! I have 3 pairs of 6807 VSS switches. Each stack is single supervisor VS-SUP2T-10G. Current version is (s2t54-ADVIPSERVICESK9-M), Version 15.1(2)SY6ROM: System Bootstrap, Version 12.2(50r)SYS2 Recommended version iss2t54-advipservicesk9-mz.SPA....
Hi, Happy New Year! I was wondering if it is possible to change the boot mode from install mode to bundle mode without reloading twice (once to change the boot mode and again to upgrade). I ask because we have a fleet of 3850 stacks running 3.3.5SE w...
Hello, I ran into an issue when enforcing 802.1x authentication on a switch stack with a different IOS from our other 3850 stacks. This is a new issue where the attached PC shows as authenticated correctly on the switchport and on ISE but the PC can'...
Hi Marcelo, The DHCP is reachable, it is only some devices that have this issue. They all have the same network settings and we can see the lease going to the MAC address from the DHCP server.
Hi Muhammad,That is correct, if a device fails 802.1x or mab authentication it should only have limited access to the network. This limited access will be to AD server, DHCP, dns, etc. Also we should be able to connect into the remediated PC to troub...
Hi Muhammad,Thanks for your input. Is multi-domain and multi-host the same thing in this configuration? If we have to do it the other way around we have many different switches across different locations with multiple VLANs. Is there a configuration ...
That should work, the only thing I'm not sure on is CSCva82153 cat6000-firmware Multicast traffic black-holed with Nappar LC mixed modeWe are using some multicast for CCTV but I don't know what that means. Could we do FSU to 15.4(1)SY safely? My only...
