Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I try to setup a VPC Domain with two Nexus 5548 Switches. We cannot use the copper port of mgmt0, so I would like to ping with a vlan interface, because we have no L3 modul.
I'm able to ping the peer-Switch but the vPC doesn't come up. Am I re...
We've integrated SG300-10 into Cisco Prime. The only things I can see, are the following: "Operate.Device Work Center.Device Details.System.Summary" and "Operate.Device Work Center.Device Details.Interface". Is there anybody, doing other things with ...
hello,I can't see why this setup shouldn't work: https://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/mkt_ops_guides/513_n1_1/n5k_L3_w_vpc_5500platform.html#wp999392 , there is a guide to configure a vlan Interface as Keepalive-Interface...
hello,
today I set the bpdufilter on both keepalive-ports and rebooted. The vpc came up and stays up. A test ping within vlan 2 (peer-link) is successfull.
Refering to the quote: for N5K I saw also a guide for using SVIs (missing Link here). The SVI ...
hello,
when I use the mgmt0 port and move the ip addresses to mgmt0, the vpc comes up withaout any problems.
But I need to use two SFP-ports. I think I have a problem with the spanning-tree setup.
I recognized that on one switch the port of the Keep...
