Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I currently have a 2960s (had the same issue with a 3750G and 3750X) that has a crossover cable connection going to a Netgear switch. I also had this issue with a TP-Link, which was swapped to the Netgear as a solution attempt. The port goes do...
Hello! We recently switched from a WLC 2504 to a WLC 5508 controller, which is proving to be a huge mistake. First off, the massive nature of the 5508 v. the 2504 ... absolutely ridiculous! The 5508 has been configured almost identically to the 2504,...
Hello!
I am at a complete loss as to what is going on with my network. Everything was working fine, for as long as I can recall, until the other day.
My APs will not join the WLC, and I have no clue as to why. I have reset the WLC as well as a few o...
Then it must hold true that Cisco does not play well with non-Cisco devices. I started with a TP-Link, and thought that was the issue, which is why I switched to the Netgear. I only needed something very basic, with PoE, to power some cameras and an ...
For a moment, I got excited about the 'mdix auto' ... but that didn't work unfortunately. Please see output below for the following:sh controller e Gi 1/0/14
sh run interface Gi 1/0/14
Hello!Ended up going back to the WLC 2504. Speeds are back near 300Mbps, much lower than the Cisco APs and broadband connection can do; however, faster than what we were getting with the AIR 5508 WLC. The 5508 is 10x bigger and consumes more wattage ...
I should add they are connected to a 2960s switch. I may have moved the port connections around during the WLC swap. How should the ports be configured for the WLC and APs? I may have them as switchport mode acsess for everything.
Hi --It's a residential setting with ~ 25 clients with ALL devices (PCs, Smartphones, Tablets, TVs, etc.).We have (4) 3702I APs and (1) 1552E..also in the process of getting a 1562I up and running as well. I would never expect to see LAN speeds with ...
