Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm wondering if someone could give me a hint please.I have two WLC 5508s in two different branches/countries. They have APs configured as Flexconnect with local routing. However all the APs are only on the first controller as the controller IP was...
Hi GuysHope someone can help me here. Is it a good practice to use a private IP (10.1..) for example for interface vlan 10 on the public side of the network for the management of the switch? Basically I have a cisco switch that connects the ISP route...
Thanks for the quick reply. I'm planning to configure only one WLAN/SSID for all the branches and assign this to one AP group where I will have all the APs in. This will make it easier to set up and manage I guess. I was looking for brief steps of co...
CollinThe three options look good and you are right "most secure to least secure". The 3rd option is pretty much the same what Jon suggested (Thanks for the attachement).The best and most secure solution will be to purchase a switch with a dedicated ...
JonJust one more question. No machine on the outside "should" directly be able to to talk to the private IP address. (vlan interface 10)? It isn't routable, only from my internal L3 switch as per diagram. How would that become visible?
JonThanks for the detailed explanation. I thought I would get a similar answer. Your solution would most probably work, however just for the sake of managing it from my desk, I think it is best to leave it unmanaged.
