Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am somewhat new to Cisco so I apologize if this in the wrong forum. I am attempting to replace my CenturyLink modem with my ASA 5515x. I configured an interface using PPPoE and the credentials they provided. I also put the public IP addre...
First, let me say I am VERY new to cisco firewalls. I am not really very well versed with IPSec tunnels either so I appologize if I sound like a boob. I sure could use some help here - cisco TAC has done all they can and my counterpart is far from ...
For anyone else who runs into this - radio_city nailed it. I found that my Public GW IP address became my firewalls IP address. I did not need to put an IP address directly on the device in this instance.
Even when I put that route to outside it doesn't allow for connections. Very strange - The packet tracer in asdm shows success when I put in packets to the outside but I just cannot get there. I cannot even ping anything outside.
show nameifInterface Name SecurityVlan1 inside 100Vlan2 outside 0homeASA(config)# show ip addressSystem IP Addresses:Interface Name IP address Subnet mask MethodVlan1 inside 192.168.7.1 255.255.255.0 manualVlan2 outside 63.227.7.41 255.255.255.248 ma...
homeASA(config)# packet-tracer input inside tcp 192.168.7.165 12345 8.8.8.8 44$Result:input-interface: insideinput-status: upinput-line-status: upAction: dropDrop-reason: (no-route) No route to hosthomeASA(config)# But there is a route? Is there a ...
well thats weird - I think I did everything and it still doesnt exactly work. here is the original Show Run: interface Ethernet0/0switchport access vlan 2!interface Ethernet0/1!interface Ethernet0/2!interface Ethernet0/3!interface Ethernet0/4!interf...
