Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,So I have this question:I have two routers connected together with two serial cables (networks 192.168.1.0/30 and 192.168.2.0/30), where on each router is loopback for testing purposes.This is my initial setting:Router1:Gateway of las...
Hello everybody, I have questions regarding Cisco TelePresence C: I know that you can call to landlines and mobiles as well from these.I would like to know little bit more technical details about this:- what else should be part of installation TP C s...
Hello everybody,I´d like to buy RV220W router, but I need it to have IPSec support for Android devices (after reading different topics here + advices of my friends, I´m not sure it does) and I must be sure before I buy it.What I need is complete ( ! ...
Hello Paul, After debating this problem with my classmate, I found out it is enough for us to do one OSPF route (primary) and one static route (secondary), simply because we do not have yet the knowledge to do what I thought we should do (both OSPF, ...
"At this point if you dosh ip routeyou should now see two paths on either roruter to the loopback address of the other router"No, this is what I see when I did exactly what you described (+ turned on the serial interfaces, otherwise only loopbacks ha...
Hello Paul, I apologize for later reply.I was able to follow them, but I haven´t been able to work this out.I tried to put that solution in the very same way as you describe, then also on a restarted routers - no luck. Thing I don´t understand is why...
Hello Paul,Dang, You´re right - I should have made the 192.168.1.0/30 learned through OSPF, then it should work.EDIT:// You know, I am trying to make the primary route learned through OSPF and I changed the secondary route Admin. dist to 200 so it wo...
