Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,we are currently trying to establish IPv6 between two routers. The routersare connected to 3560G switches (c3560-ipbasek9-mz.122-58.SE2).We have some issues with IPv6 neighbor discovery, the routers did not seeeach other in neighbor table (IPv...
hi community!i have an ASA with 9.1(1) which is accessed on its inside interface (from outside) via "management-access inside" command. after upgrade to 9.1(3) this stops working. ADMIN outside ASA inside inte...
hmm...now that the new SG350 switches are released, what about the IPv6 support? I assume they should be able to route between IPv6 (vlan) interfaces without any issues.
does anyone have experience with the new SG350 switches? can they handle dynamic...
Hi Seb,
the 3560G does not support any IPv6 commands right now. It might support IPv6 L3 commands after setting the SDM template to
sdm prefer dual-ipv4-and-ipv6
We thought that they just switch the IPv6 packets between the routers, so it must n...
hi,thanks for your reply.behind that firewall there are serveral other firewalls all connected with each other via one single /24 transit network. the idea was to access all firewalls via their addresses in this transit network (naming conventions......
