Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I am trying to set up ospf from a nexus 9k switch running 9.3 code to an asr 9001 router running code 6.2.3. Below is my base config but i am not able to get the ospf to form. Am i missing something as this looks to be the correct config. Ne...
We have a client on our asr 9K router that we are providing layer 2 transport for to several sites. The client has asked us to also provide data center space for a remote server in our data center. Is there a way i can pop off the customers vlan on ...
Hello We have several links to different IXP's in the region and also BGP sessions with several upstream providers. What i am trying to do is if any ASN is located in any of the IX that we peer with we then want to remove the routes that we get from ...
Hello I have a cisco layer 3 switch set up as a core switch with layer 3 routing. I have also set up a mgmt vlan and facing some issues. I am trying to set the switch up for all switch level traffic the SVI for interface vlan 500 should be used. We ...
Hello I am working with cisco IOS XR and ASR 9K router. We are trying to set up a new client with Layer 2 transport with the below config. We are using ASR 9K as our main router in the data center and cisco 4500x units still in our sub site location...
I am still not able to get OSPF to come online. Does anyone have a base config they can share for cisco asr and nexus 9K switch for ospf. This is a breeze in regular IOS.
Here is what i have installed. disk0:asr9k-doc-px-6.2.3disk0:asr9K-doc-supp-6.2.3disk0:asr9k-fpd-px-6.2.3disk0:asr9k-fpd-6.2.3disk0:asr9k-mgbl-px-6.2.3disk0:asr9k-mgbl-supp-6.2.3disk0:iosxr-mgbl-6.2.3disk0:asr9k-mini-px-6.2.3disk0:asr9k-scfclient-6....
The 2 interfaces you see is for the 2 sites we provide transport to. The customer now wants us to locate a server in the data center and we will provide a 1 gig port to the server and add it to the bridge domain. We need to be able to pass the client...
Our main uplink port to our asr 9k is a trunk port. My main question is if i am using vlan 100 and the customer is using vlan 100 can this cause issues ?
So if i am using vlan 100 and the customer is using vlan 100 will that be an overlap on my network with this setup?Should i move over to a higher vlan number?
