Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have ASA-5512-IPS, and i configured the asa to forward traffic to the IPS in inline mode. but i don't see anything on ips reports that indicates that there is a traffic pass. all reports are 0 in the IME software, which is not right i suppose. Is r...
I have my IPS configured auto update signatures. It successfully downloaded the last signature, but i still see an old one installed on the IPS.You can see in the following sh version that the last installed signature is 616, while the last one downl...
Hi, I previously was able to open ASA5512-IPS from ASDM, but now I can't. it gives me error "ASDM 7.3 (2) doesn't support IPS 7.1 (3) E4" So what should I do, upgrade IPS or ASDM or do what exactly ? I want to use ASDM not IME or anything else. Also...
I need to know how to configure HTTPS inspection on ASA ?All i can find is http inspection and it seems that I can't add 'inspect https' command ? so what i can do ?
I get this error on a 3650 switchInsufficient Power for POE/UPOE device. Replace with compatible FEP and Power-Cycle the SwitchAny Idea what causes this ? Is this a hardware problem or what exactly ?
I found the solution by coincidence, I changed the security level of management interface on ASA from 100 to 0 and suddenly all reports started to appear on IME. I don't know why, this what happened.
I tried two IME versions on two PCs and all the same. so I don't know what is it.Do you know any other software for IPS reporting ? and btw I can't use ASDM for some reason. It always says unable to load sensor.
I tried two IME versions on two PCs and all the same. so I don't know what is it.Do you know any other software for IPS reporting ? and btw I can't use ASDM for some reason. It always says unable to load sensor.
