Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to create a voice lab, I have a 1700 series cisco router and a 3500lx switch. I have configure the vlans,and trunked fa0/0 on router and fa0/1 on switch, i and unable to create a interface range fastethernet fa0/2 - 24. I get a invali...
I get a invalid input range &nbSwPodx(config)# SwPodx(config)#int SwPodx(config)#interface range fastethernet 0/2 - 24 ^ % Invalid input detected at '^' marker. SwPodx(config)#sp;
Looks like in for a lot of work arounds and trouble with this switch, what is the next level switch that will support the lastest ios commands, also would GNS3 be a better option, because this just lab 3 in the book and im spending to much time res...
This is a voice lab and think I will be using Ip Phone and PC together. vlan 10 is Data for PC vlan 15 is Voice for IP Phone vlan 11 is Management for gateway Maybe this is why I have to assign 0/2 - 24 to vlan 10 and 15 correct ?? my vlan config...
Looks like in for a lot of work arounds and trouble with this switch, what is the next level switch that will support the lastest ios commands, also would GNS3 be a better option, because this just lab 3 in the book and im spending to much time res...
Looks like in for a lot of work arounds and trouble with this switch, what is the next level switch that will support the lastest ios commands, also would GNS3 be a better option, because this just lab 3 in the book and im spending to much time res...
Jon this is a voice lab and think I will be using Ip Phone and PC together. vlan 10 is Data for PCvlan 15 is Voice for IP Phone vlan 11 is Management for gatewayMaybe this is why I have to assign 0/2 - 24 to vlan 10 and 15correct ?? my vlan conf...
