Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need to convert AP type 2802i from Mobility Express back to lightweight.So far have done hard reset, and when it boots it restarts config wizard for ME. How can I remove ME and make it join WLC againt ?thanks for help !
Hi, Here's the problem we are having:Network 1 is network with 2 cisco 4510 core switches in hsrp mode.Network 2 is network with HP 5800 core switches (2) stacked together. Goal is to link these networks with port channels from both cisco's to HP sta...
Hi,since a few days I cannot access the web interface anymore via wired lan. I can ping the management interface, but all other communication via wired lan fails: no web interface, no authentication anymore to radius server, cannot upload configs or...
I did indeed a "reset system" this morning, just like I did this afternoon. However this morning it didn't solve the issue, and now it did.Anyway, thanks a lot for a VERY FAST response. This is quite reassuring.Koen
Hi,It is not a case of duplicate ip's: at reset of the system the pings stopped, and started again when system was up again.However after this reset, i can connect again to web interface via wired link, for now at least.
Hi,I can connect to the console (via console cable), Guest users can still connect wirelessly (static key), but ssh does not work (although it is allowed in the configuration). Telnet is not allowed.Basically I can only ping via the wire.
