About virgilv

virgilv · 09-20-2004

I am trying to figure out different ways for configuring dynamic tunnels between two routers, in which either side could initiate the tunnel.I have played with DMVPN, however this really relies on the spoke router "registering" with the hub, thus ini...

virgilv · 10-02-2004

With regards to DMVPN, what if I used "ip nhrp map x.x.x.x y.y.y.y" on both sides. I know you typically use a static map on the spoke side only, but I tried this and it seemed to half-way work. I'll explain:I set up GRE tunnels with DMVPN and adverti...

virgilv · 09-29-2004

I think I inadvertantly tried what you are talking about here. And I think you're right - IPSec SA's can be initiated from either side.However, with DMVPN's, the spoke registers with the hub upon booting or if the outside interface should go down and...

virgilv · 09-24-2004

Well, that is good info, however I had counted TED out because (I don't know if I mentioned this before) there is a requirement that one side doesn't use dynamic crypto maps.My "hesitation" about TED and routable IP's was that the IP's have to be "pu...

virgilv · 09-21-2004

Uh - let's say both have static addresses and / or one could have a dynamic address.This is a little problem I have been trying to figure out for a while now and I just can't seem to find the right combination.

Member Since	‎11-11-2003 08:02 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	5

User Statistics

User Activity

Dynamic VPN Tunnels

Re: Dynamic VPN Tunnels

Re: Dynamic VPN Tunnels

Re: Dynamic VPN Tunnels

Re: Dynamic VPN Tunnels