Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We input MAC addresses one or multiple at one time, then distribute to 10 APs and works fine. Then we try to remove one MAC and distribute to all APs and it does not distribute to all, only removes from that one AP.Ernie/CA.
Our environment is a Cisco router that use to point to a different DHCP on the far side. Were trying to initiate a new Netware DHCP on this side, so we changed the pointer on the router, and clients get either nothing or wrong subnet. Running NW6sp4...
We want to configure only trusted MAC addresses on 1 2950 switch. So I am thinking of a static entry such as "mac address-table static xxxx.xxxx.xxxx vlan 60 interface range fastethernet0/1-10" for the 1st 10 ports, has anyone done a similar thing??T...
SOLVED by this following message,see: DHCP and VLAN/Routing Wierdnesshttp://forum.cisco.com/eforum/servlet/NetProf;jsessionid=wdtaag8g71.SJ2A?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd5e155Incorrect Netware6 DHCP Configuration...
The superscope explanation fixed our problem too for Novell Netware. The terminology is different but it works the same way, thanks to everybody's input here.Ernie/CA.
Option 1: Upstream port= GigabitEthernet Interface on a Catalyst 3550, currently with this configuration.(in show run). Question: Will setting this to access mode (for secure port) nullify all/some/most of this configuration? FYI: This is the 2nd to ...
My plan then is to use the Port security method on all 48 ports on the 2950 switch using the interface range command (ie) (config)# interface range fastethernet0/1-48then these commands:switchport mode accessswitchport port-securityswitchport port-s...
