Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day Cisco people,I am Simon and I have a big situation. My company recently expanded to one of our branches. Now this branch houses 100-150 employees. They are using computers and IP phones.Currently, Our voice and data are integrated into one n...
Hello again,I just want to ask how can I configure bridge priority of a Cisco Switch. I have a Cisco 4506-e L3 Switch and I want it to be the root switch/bridge.I also want to know if there are any bad effects or negative effects when I configure thi...
Good day CSC,I am trying to configure an acl to deny rdp traffic on one of our server which has a static nat from one of our public IP. How can I configure it without dropping all other traffic? Will these configuration do it? access-list (acl name) ...
Good day CSC,I am trying to configure an acl to deny rdp traffic on one of our server which has a static nat from one of our public IP. How can I configure it without dropping all other traffic? Will these configuration do it? access-list (acl name) ...
Good day to everyone,A few minutes ago as of the writing of this discussion, a colleague of mine tried to enable a dhcp server using a vmware. He is unaware that he is actually distributing IP's in our local network. So the inevitable happened, 40 co...
Mr Florin and Mr. Joseph, I need your help. My network is messed up bigtime. I have a port configured to access vlan 7 but its getting an IP from vlan 5. The Core Switch is acting as the DHCP server and is VTP status Server while the Server switch is...
Thanks for the Reply Mr. Joseph, I just want to clarify something. What do you mean by this? #### Configuration only to be applied to ROOT ####What if I want to make a switch that is not a root to be THE root? In my case my DHCP server/L3 Switch. Ma...
Thank you mr John for your reply,I just want to clarify if I can configure dhcp snooping without this dhcp agent? is it mandatory?And for example: I have this kind of setup ( you can check partial configuration) where I have the l3 4506 switch config...
