Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Version 8.3.133.02960SAIR-AP2802I-E-K9I'm trying to reclaim some power budget on a 2960S so that I can power more 2802I.I've been using variations on the following:power inline static max 26000power inline auto max 26000power inline consumption 26000...
We have CPI looking after two controllers, a 5520 and a 8540.I have created new WLAN AP groups on the 8540 but they are not being updated on the 5520 as I would expect.Oddly, the running config on the 8540 (thorugh Inventory -> Network devices -> All...
Here in the UK, my region code is "E" - so the LAP I install would be e.g. a 1815W-E-K9.
BUT, I have some 1815W-A-K9 and country AR for Argentina. Obviously these will be mixing, within the same building and controller, with existing LAP with region ...
I'm sure, in Prime 1.1 inventory reports it used to give the name of the switch that the AP was connected to.
Now, the report inventory offers no such thing.
How do I get Prime Reports to give me an inventory of our AP and the switch port they are ...
I've been asked to cover three large farm buildings.
The Cisco 1572EAC - external antenna and AC power is what I'm looking at.
Can I mount one inside one of the farm buildings, and have a 5GHz external antenna mounted on the outside of the builldin...
Indeed, but I'm in this ridiculous situation where I have a 24-port 2960S with 215W of spare capacity, but because of the way the power is reserved, I only have access to 29W of that 215W. I just want access to that spare capacity, and not have it re...
Indeed, but I'm in this ridiculous situation where I have a 24-port 2960S with 215W of spare capacity, but because of the way the power is reserved, I only have access to 29W of that 215W. I just want access to that spare capacity, and not have it re...
I too have this exact problem.No, the MIC thing doesn't work.No, adding that wlc address manually doesn't work.It looks like I will have to manually downgrade the software on the 1562I.Regards,Mal.
