Hi community,I have a doubt about upgrading a switch Cisco Catalyst 9400. Beside to the software image upgrade, the Release Notes say “ROMMON and CPLD version upgrade process must be completed after upgrading the software image.”. Is this true? If so...
Hi community,I am configuring a SG200 switch for integration with a NAC, I want to authenticate users (802.1X) and phones (MAC), so I need to configure ports with "802.1X and MAC" option. According to the switch guide this is possiblehttps://www.cisc...
Hi experts, It was long time ago when I studied BGP, and these days I was doing a lab and got some issues related with the BGP router-id. I found this post:https://community.cisco.com/t5/routing/bgp-router-id-and-loopback/td-p/1611333Herve says "The ...
Hi guys,
I have a default route which is tracked, the track is up, but the route is not being placed in the routing table. I copy only the relevant configuration:
!track 1 ip sla 1 delay down 9 up 3ip route 0.0.0.0 0.0.0.0 10.20.15.1 track 1ip r...
Hi community, I need a tip for the following scenario. I have two branches with routers 1 and 2 (R1 and R2). I want R2 reaches the Internet through the upper path (MPLS A), and in case there is something wrong here, it goes through the lower path. Fo...
Hi Leo,One more doubt. When you upgrade the CPLD there is an inconsistency between the CPLD version of the supervisors, and the CPLD version of the line cards, also docummented in the upgrade guide:When performing the CPLD version upgrade as shown, t...
