Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it possible to change the port type (access to trunk or vice versa) from the local device page or is a factory reset the only option? I had a look around on the local device page, but I couldn't see this as an option on the switch ports configu...
Currently our Sonicwall firewall is directly connected to our Meraki MS425 core switch. The Sonicwall is in the same vlan as the corp data vlan, with a default route on the Meraki to the IP of the LAN interface of the Sonicwall.In preparation for a f...
Hi there,I've just had my first experience with configuring the wired ports on a MR30H, and I'm just trying to wrap my head around why Meraki is using SSIDs and port profiles, instead of the same method of configuring the wired ports as the MS switch...
Hi PhilipDAth,Thanks for the confirmation.I actually found an old TZ400 in our storeroom, so was able to lab this up with 2 Meraki switches (MS350 and 320) about 2 hours ago, and confirm what I suspected and you had confirmed.The SVI I created was al...
Thanks for your thorough explanation MerakiDave. That makes sense.We were intending to use the device for an area in a building that only had 1 CAT5e run, to run an AP and power 2 IP phones and connect the laptops via the phone. We had a spare MR30H ...
