Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Two routers are conneccted with each other & tried to filter router1 loopback address using route map with extended acl.But still its not filtering routes & incase i use standard acl it filters the routes.below is the config of both routers.Router1:-...
Hello everyone, My question is not related to running conversation but its related with ACL logs. Please let me know how can i enable logs on running access list.Suppose I have access list there are certail permit /deny statements.Now my manager want...
Hi,
How can i filter specific access list between source IP & destination ip with port no(tcp/udp) using show command.Suppose below is the source & destination.
Source IP is 192.168.1.1
Destination IP is 10.1.1.1
port no. is (tcp 22)
Firewall is be...
HI, I am getting undersize error on port that is going towards router.I am not sure what is the reason behind it.Please guide me how can i stop increasing undersize error on port & what is the reason behind it. Port Align-Err FCS-Err Xmit-Err Rcv-Er...
Hi Julio, Tested & i can confirm route 192.168.1.0/24 have been removed from routing table.But my concern is different.same access list is working inca se of distribute list , but if i apply same access list in route map for filtering , then it doesn...
