I have an issue with poor response times to my 2950 switches. Is this a buffer issue.#sh buffersBuffer elements: 498 in free list (500 max allowed) 15748070 hits, 0 misses, 0 createdPublic buffer pools:Small buffers, 104 bytes (total 60, per...
Do not install Java 1.4.1_08 patch for LMS 2.2 as DFM 1.2 Admin and Monitoring consoles cannot be displayed. The e-mail notification still functions though.Cisco TAC have informed me that the Patch is not supported in LMS 2.2 but the release notes d...
I'm getting a large number of giants reported on my Ten Gig Interfaces. Any ideas why and how to stop this?TenGigabitEthernet1/2 is up, line protocol is up (connected) Hardware is C6k 10000Mb 802.3, address is 0011.5cdd.4699 (bia 0011.5cdd.4699) M...
I have some 3750 switches with the same issue. They support "show running-config brief" command and the protocol order has Telnet & SSH before TFTP. I can also confirm that the config is being fetched using Telnet.Any ideas?LMS 2.5 & RME 4.0.4
Sounds like a module failure, which needs to be returned to Cisco. However depending on your Supervisor Module type it may not be supported in Slot 10. I know there are limitations on certain modules slot location when using a Sup720.
Yes, I do mean ping & telnet responses, sometimes response times are over 100ms. The IOS on the Cat2950 Switch is 12.1(22)EA4CPU peaks at 27% Memory Used peaks at 80%Ciscoworks DFM also reports 'invalid snmp response' alarm as well.