Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I've been asked to take advantage of an upcoming plant outage to do some firmware updates on an active/standby pair of ASA5516 protecting an ICS/OT network. These firewalls are currently running ASA 9.10(1)22, ASDM 7.10(1), and have FXOS 2.4(1...
Hi Folks,I'm a long time network engineer, and this is my first post here. I've worked with Cisco enterprise products most of my career, but have also worked extensively with Fortinet, Palo Alto, Aruba/HP, and Checkpoint devices. A former colleague...
I have configured vrf-lite lots before in IOS and IOS-XE, but this is first time in NX-OS. We have a brand-new 10Gbps L2 fibre service to connect two sites together, but I want to test it before trying to migrate production traffic to it. All I’m tr...
Hi,
First-time user. I have not received the "2nd e-mail" promised to me for the VPN credentials to access my active reservation in Devnet Sandbox. I'm guessing its because the lab failed to setup properly as per the errors I'm seeing, which incl...
Thanks @Sheraz.Salim for your reply. These firewalls have FXOS 2.4(1.244) installed, but the Firepower module is not being used at all and I just wanted to be sure that I wasn't going to run into problems treating these the same as older ASA firewa...
Yes, I forgot to mention it is an L3 interface. I'm looking at the "show ip arp vrf test" output and getting nothing. Interestingly, when I look at the management VRF arp table I don't see the MAC address or IP address of interface Mgmt0 either. P...