Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I configured my syslog server and I reiceive the body of the message, but I don't have the host (Attachments1.jpg).
Here the command in the cisco:
logging origin-id string PAR-COT-SR0
logging facility syslog
logging host xx.xx.xx.xx
Any idea ...
Hi,
I have a problem when I want to access to my 2960x by SSH.
In fact, when I use the "Admin" account, I don't have problem to access.
But I want to use another accout (mle), I have an access denied. I don't understand why because I created the ac...
Hi,
I don't know if I am in the correct category but here my question:
I bought a cisco 2960X-48TS-L and I would like to know if I need to active a licence ?
Thanks.
Hello, I created a network with 3 VLANs and a DHCP server but I can't access to Internet except the native vlan.I use an 2960X device who are connected to a Checkpoint Equipment. I had configure the checkpoint with an IP who's part the native VLAN an...
Ok, I activated the raw file and I don't have nothing for the host.
But when i see screenshot about the program, the host column is entered.
I don't understand where is the problem because when I see screenshot about the software all columns work...
192.168.50.1 is the interface of the switch
And yes i can ping from and to switch <-> syslog.
I receive all informations concerning the log except the host.
Hi,
I added the command but unfortunately the result is the same: I don't have the information with the host.
For information, when I enter the command: "show log", I have this configuration:
099308: Nov 2 10:15:56: %LINEPROTO-5-UPDOWN: Line pro...
Hi,
When I said "I don't have the host", I wanted to say, I don't have the name or the IP of the concerning host (see my attachment and I hope you understand).
Thanks.
