Currently all alarms /traps from the controllers are forwarded to Prime. Prime then forwards them to solar winds. If prime goes down can the controllers be configured to send the traps/alarms directly to solarwinds? Having prime an...

This card will not start a code 10 appears I have a green activity light but will not start, i have updated the drivers. In the resources section no IRQ as been assigned

1.I have 900 yards to bridge two bulidings can I set up two Cisco 1200 AP'for that bridge?2. Point to multipointI am bringing up a point to multipoint network, besides setting; data rates @11mbps, turn off broadcast SIDD, set point as ROOT and multip...

This concerns the 1100 AP I cannot access the HTTP page I can use the IOS. is there a command/switch that turns this function on. New out of the box I can but when I load the script I cannot get HTTP I have review the scripts commands to no avail any...

Is there a setting in IOS for the 1100 and 1200 that we can set so the AP broadcast the physical(ethernet) address. On site survey's we record the Ethernet MAC address in our data base but when I return to do post survey the AP is broadcasting the r...