Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running IOS 12.1(13)EA1a on a C3550-24-PWR. We have wireless access points that are connected and receiving inline power from the ports. Today, all of the access points' interfaces changed to down for no reason that I could tell as indicated b...
I would like to test my T1 cards in 2 different routers in the same site without using a T1 line. I thought I read a tech article a while ago that through either software or a special pin out with a CAT5 cable, that one could create a serial connect...
Here is the setup:2 2600 routers on one LAN on the same subnet. The serial interfaces are connected to 2 point to point links that terminate into 2 other 2600 routers, each with a fastethernet on a separate LAN. Example:Lan 1 - fa0/0 - 10.10.10.1/24 ...
Is the software Cisco VPN client v4.x for Windows and Linux free of charge as long as it is used to connect to a VPN concentrator, PIX or relevant IOS release on a router? If that is correct, are you allowed to use any version of the client and upgr...
The 2621 can process 20 kpps. Does this mean per interface? A combintation of input and output packets/sec? When I do a "show int fa0/0" on my 2621, I see for 5 minute output rate and 5 minute input rate, each at about 150 packet/sec. Does this m...
Thanks for all your posts. I have just decided for the interim to put both LAN2 and LAN3 on the same subnet making them both LAN2 and use floating static routes towards each router's fa0/0 for PTP failover only.Vincent, Your post is exactly what I ...
OK. Thanks for the reply. BTW, both LAN 2 and LAN 3 are in the same site.I have 2 more questions.1. It seems this setup will route LAN 2 and LAN 3 over the same link at the same time. I need to make sure that LAN 2 routes over its point to point a...
Thank you for the post. I appreciate your insight. When you say, "PPS ratings are total", do you mean both input and output ratings added together on all interfaces, or just one way on all interfaces?Thanks,RJ
OK. Is there a list that explains exactly what is available to use in the basic vs enhanced since it seems that all commands are available in both images?Thanks,RJ
Thanks for your response. What do you think about the layer 2 redundancy setup that I mentioned? Should I use that using STP or just disable STP on the entire switch? Is there another way to have redundant links between the 3 4500's?Thanks,RJ
