Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am looking for ways to suppress alarms between two host groups. I do not want any alarms when the host in these groups communicate with each other. In the Host Policy, i can create a policy for a specific host group individually, but i did not ...
Hi Team,
As per the below table, there are limits on IP-SGT bindings for relevant switches. What i want to know is, how are the L2 and L3 limits calculated? What parameters does the TrustSec feature check in the 4500 series switch to build up this li...
Hi,I am looking for a best practice guide for setting up SXP connections. I went through the basic ones that are available. I am looking for few suggestions on best setting up SXP tunnel between 9 C3650 switches. I observed that when SXP tunnels are ...
Hi, Can someone share few sample reports of the TrustSec Monitoring mode? I want to see the different kind of reports that may be available to me once Monitoring mode is enabled in TrustSec policy. ThanksTJ
Thanks unmahar, but my query is specific to how the switch classifies the IP-SGT binding as L2 or L3? Is it because of the way the switch has learned the IP details, or is it because of routes, vlans etc?
Hi Jeaves,Basically i want to see few sample reports that the ISE can give from TrustSec "Reports" section related to TrustSec Monitoring mode. ISE version is 2.2 patch 6For a switch/router i may need to rely on syslog or netflow.
Hi Jason,I have a customer who is setting up a smart city with lot of smart devices like smart lamp posts/pole, cameras, digital signs, parking sensors, temperature sensors etc and is looking to securely control them. Many of these don't have the cap...
