Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Getting error when trying to configure Diagnostic interface on the same subnet as management interface. i have a management switch as the gateway and FMC/SSH can get to the FTD via management ip without any issue. I need diagnostic interface for SNMP...
Here are the configs i applied on the FMC under Objects - Flexconfig object
bfd-template single-hop TEMPLATE1interval both 300 multiplier 3echo
interface Port-channel3.858 (Interface facing BGP peer)bfd template TEMPLATE1
Once done attach them to yo...
Hello MikeThanksMy ideal solution would've been doing posturing on DLP version however i will try your suggestion by just checking if the software is installed/running and see how that works out for me.
The issue is basically caused by dynamic routing, in my case i need to remove bgp configurations, setup the ip address of diagnostic interface and reconfigure the bgp. Below link has more details https://finkotek.com/cisco-asa-error-address-is-in-us...
