Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have implemented WSA S195 as an edge device. M1 -management interface, P1- facing LAN with private IP, P2-facing Internet with public IP. It appeared that P2 interface responding to ping and HTTP requests. Is it possible to filter/block thos...
Hello everybody,We have two new WSAs S195, which we would like set up as an edge device. So P1 inteface facing LAN (private IP subnet), P2 interface facing WAN (ISP Public IP address) and M1 is only management. Will it work like this?ThanksAndrew.
Hello all,
We have two physical vSphere 6.0 hosts. One is a primary host which contains production VMs and another is a backup host for backup VMs. Production FMCv is up and running on primary host and connected to two ASA5516-X physical device and o...
Thanks. I thought WSA is a security appliance and is not require additional protection Actually we scanned P2 interface by Qualys and it did not found any major vulnerabilities. So there is no other solution than put WSA behind firewall?
Thank you Massimo.
I am not going to change IP address of FMCv. I just want to clone current FMCv to other physical VMware host(server), shut down current running FMCv and power on cloned FMCv. Nothing change except FMC virtual machine copied to othe...
Yes two VMs are absolutely identical and located in the same subnet. The only difference in they are located on separate physical servers (VMware hosts).
Thank you Marvin. I have also opened a ticket with TAC and they tried it in their lab and told me that it should work but I will need to reregister SFR modules and 2120 FTD device. I am now thinking about access control policies which already created...