Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Cisco Community
I recently ran with a project using Aruba wireless equipment and they have a very cool command that displays the amount of DualBand (able to connect to either 2.4Ghz or 5Ghz) clients that are on the network and which network the...
Hey Everyone, I'm hoping someone has found a cool way of doing this, I have a number of WLC placed around the country and we offer a free BOYD solution to our staff and guests. I have had it on a number of occasions that I run out of IP addresses an...
5760 Wireless Lan Controllers running 3.61 became unreachable and had to be rebooted, it appears to be affected by the following bug CSCus92830. Will upgrading to 3.7.0 fix this problem
Hey Robert thanks for this write up I see the Z3 units are only able to do 802.1x authentication on the wired ports, how did you guys go about extending your corporate SSID to the home users and were they able to authenticate against your Cisco ISE s...
You need to ensure that the new SNMP community string is associated to the SNTC IP address (or range) on the controller otherwise the controller will reject the SNMP query.
You gave me a political answer back, my question was "is there a command that will show me the amount of dual band clients I have on my network and which network they chose"
Your answer was insightful and correct but I still have no idea if there is ...
