About Nolan Herring

Nolan Herring · 05-31-2013

Hello all,I was just reviewing the config guide for 7.3 and HA-SSO and then I found out that with 7.4 it allows for an N+1 scenario.http://www.cisco.com/en/US/prod/collateral/wireless/ps6302/ps8322/ps10315/qa_c67-714540_ps2706_Products_Q_and_A_Item.h...

Nolan Herring · 10-14-2012

http://www.cisco.com/en/US/docs/wireless/controller/7.3/configuration/guide/b_wlc-cg_chapter_011.pdfFirst statement:For Cisco 5500 Series Controllers in a non-link-aggregation (non-LAG) configuration, the managementinterface must be on a different VL...

Nolan Herring · 09-12-2012

Hi everyone,I have a setup of 5 non-root bridges going to a root bridge. We setup a second root bridge on the same pole for redundancy (same config, minus hostname and ip address)I split up the non-roots, so that the two important ones would go to ro...

Nolan Herring · 10-10-2013

The only way to do this, other than through a WLC and as far as I know, is through ROMMON. This came directly from TAC.EXAMPLE:Autonomous image used: c1520-k9w7-tar.152-2.JB.tarGive your laptop a static IP (example below uses 10.1.1.2 /24)Connect la...

Nolan Herring · 09-13-2013

Say whaaat ! Dang I didn't know that.So for example, if you have a perfect square, and 4 access points in each corner (simple fake setup). Bottom Left can see Top Right at -55 RSSI with power level set to 1 on both.You then change power level to 8 on...

Nolan Herring · 08-22-2013

Nana,Just want to make sure you understood my post, i might not have been clear =)It's not 5Ghz onlyYou still have 2.4Ghz enabled, but only on select access points, so that you cut down the CCI in high density setupsIf your doing true HD setups like ...

Nolan Herring · 08-22-2013

Definetly a unique/tough scenarioKeep in mind, that the words 2.4ghz and 'high density' dont really go well together =)Your best bet (imagine a perfect square , with 100 dots evenly distributed between), would be to manually shut down the 2.4ghz on m...

Nolan Herring · 08-16-2013

That command wouldn't work for my 5508 running 7.4.110.0 codeBut this did : show run-config no-apJust a slight syntax issue =)

Member Since	‎08-11-2012 10:55 PM
Date Last Visited	‎03-13-2024 12:02 AM
Posts	23
Total Helpful Votes Received	5

User Statistics

User Activity

7.4 HA-SKU with N+1 Design

Is this statement in the 7.3 config guide contradicting?

Non-root bridges still choosing least congested over parent commands

1552E Access Point ftp, tftp, scp...

Co-Channel Interference, RRM & MCS rates

Re: High density design in Open park

High density design in Open park

WLC running config