Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup a site to site vpn up between a Cisco ASA 5508-x and a Cisco ISR 4531. The tunnel is showing up but I cannont ping between the tunnels. When I ping it goes out one hop and then I get the !N. here is some show commands from the ASA and R...
I am adding the VPN profiles to the profiles folder, but when I try to install the package it is not reading the profiles folder and not automatically adding the VPN profiles. I know you can manually add the profiles, but the installer should be able...
I am trying to configure failover with a gateway of last resort. I have 2 routers and each have there own ISP connection. One is our primary, and the other is our backup that also routes all of our wireless traffic. We have route-maps setup on the co...
Im sorry i should have made that more clear. No R1 has its own entry in the routing table for PC network from the core switch. The topology is as follows. 2 routers each with there own separate ISP, then each router is connected to a ASA, and then bo...
Router 1 Conf
interface GigabitEthernet0/1 description Link to RT-2 ip address 172.22.253.1 255.255.255.252 no ip proxy-arp ip nat inside ip virtual-reassembly in ip ospf cost 3 duplex auto speed auto no cdp enable no mop enabled!
Router 2 Conf
i...
