Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I have 2x FPR1120 and built HA between them. I am managing it with FMC which is remote to them therefore I am using outside internet to connect FPR to FMC.I am using data interface as management.I have a possibility to have backup ISP...
Hello community,recently we are experiencing random blocking of some webs on Cisco WSA with reasonReason: BLOCK-MALWARENotification: MALWARE_SPECIFICWeb is only blocked about 1 of 10 access attempts and after refresh it is loaded correctly.Seems like...
Hello community, I have 2 FTD2 (1010) managed by FMC.On one of FTDs I have 2 ISP while using SLA to switch to backup line in case of failure of primary.I did build 2 VPN tunnels between FTDs, while one is on primary ISP, second is on stby ISP.If I si...
Hello community,we are trying to test FMT in our environment and up to now we have experienced very strange behaviour.Yesterday all worked OK, I was able to login up to a point where I had to connect this tool to FMC. Since we needed some time to pre...
Hello community,anyone else experiencing issues with Duo Security Authentication Proxy running on WS2016 after latest (09/24) patches install?On ASA debug it was shown "Unable to decipher response message" (Anyconnect)After restore of server to the v...
Hi,thx for feedback.I have fixed issue in my lab by integrating FTD to FMC by its original IP address, not NAT ID (which I did to fully represent my live environment).
Hello,thank you for feedback.Cisco confirmed this as a bug https://bst.cisco.com/quickview/bug/CSCwp93076we are waiting for further steps now.. Issue is still on, however most of web pages are now loaded but it is very slow, impacting daily operatio...
