Hello, after writing this post at the forum: http://homecommunity.cisco.com/t5/Wired-Adapters/SLM2008-dropping-packaged/td-p/497730 But "iamgiantherockstar" Told me to turn to this support forum. I have recently looket at the following thread: http://homecommunity.cisco.com/t5/Switches/Linksys-SRW2008-Load-balance-setup/td-p/217487 I have also recently posted this on the QNAP forum: http://forum.qnap.com/viewtopic.php?f=50&t=56416 I don't know where the problem is, but perhaps someone here could give it a look and some tips. I am running the 802.3ad protocol and its LACP setup in the SLM2008 switch. You can see the images here: http://www.dropmocks.com/mBg-X8 The MTU is set to be 9000 on both servers and the SLM2008 Jumbo Frame enabled. Sender-Server(ts-859) Reciever-Server(ts-639) Switch Config (SLM2008)
... View more
HI I have a big problem, I cannot connect via VPN PPTP (normal setup in windows xp), I have managed to connect over VPN direct connected to internet, through the router (WRVS4400n) if I turn off the firewall. But I cannot connect with the firewall enabled. I have now run out of ideas and i hope anyone here can help me with my problem. One more thing, the device is on and I have enabled the passthrough (and 'Multicast Passthrough' in firewall basic settings) for all available options where one of the options is PPTP. I must also mention that I have recent upgraded the router to the latest firmwire version: V188.8.131.52 When I surfing around, I found this: https://supportforums.cisco.com/thread/2022465?decorator=print&displayFullThread=true Looks like there is more people having problem with the issue, but still no solution to the answer. Please help! Best regards, Tobias J.
... View more