Hello,
after writing this post at the forum: http://homecommunity.cisco.com/t5/Wired-Adapters/SLM2008-dropping-packaged/td-p/497730
But "iamgiantherockstar" Told me to turn to this support forum.
I have recently looket at the following thread: http://homecommunity.cisco.com/t5/Switches/Linksys-SRW2008-Load-balance-setup/td-p/217487
I have also recently posted this on the QNAP forum: http://forum.qnap.com/viewtopic.php?f=50&t=56416
I don't know where the problem is, but perhaps someone here could give it a look and some tips. I am running the 802.3ad protocol and its LACP setup in the SLM2008 switch. You can see the images here: http://www.dropmocks.com/mBg-X8
The MTU is set to be 9000 on both servers and the SLM2008 Jumbo Frame enabled.
Sender-Server(ts-859)
Reciever-Server(ts-639)
Switch Config (SLM2008)
