Hey!the manual method has several drawback
* it involves a lot of manual efforts and time to configure each of the devices.
* it can lead to inconsistency in the configuration due to human errors when deploying the config.* configuration updates and ...
Ideally the most common issue you face during a brownfield device on boarding is the preexisting config on the device.
You need to ensure that the device is clean without any configs/certs.
You can use the following commands for the same.
[CLI config...
You can check the following logs from DNAC CLI. You will need to access the maglev cli at port 2222
onboarding-service
connection-manager-service
network-orchestration-service
apic-em-inventory-manager-service
the time to stop the lan automation is when the device is added to the inventory.the device should be managed and reachable.
once you stop the LAN automation, the links will be successfully configured.if you stop the LAN auto before device is added t...