Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a multicast setup based on Catalyst 9500 switches which are terminating SVIs for clients and servers. There are two of them involved: the source and the client are both on VLANs terminated on one (R1), and the RP for the group in question is...
I've now found what was causing this problem. It is basically self-inflicted. Some time ago a I followed a recommendation from the Nessus software we run to block use of IP Options on our Cisco switches/routers. I followed this without much checking ...
Hi PaulHere is a diagram. A couple of things I should mention:This is all going on inside a VRF which is used on both R1 and R2. I don't think that should change anything, but I should mention it.This morning I've tried putting a client on another VL...
I forgot the mroute counts: R1 (FHR and LHR)sh ip mroute 239.255.11.11 countIP Multicast Statistics162 routes using 290672 bytes of memory65 groups, 1.49 average sources per groupForwarding Counts: Pkt Count/Pkts per second/Avg Pkt Size/Kilobits per ...
Hi PaulHere are the outputs from those commands. I've also included a couple of "show ip rpf" where that seemed relevant: R1 (FHR and LHR)================sh ip pim neighPIM Neighbor TableMode: B - Bidir Capable, DR - Designated Router, N - Default DR...
