Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I'm looking for a basic WPA configuration for AP1142n. This should allow connections upto 300 Mbps. Best should be a script config.Authentication should be local radius server.Thanks for your help.Regards,Christian
Hi,Router is always booting from the first found valid IOS image (lowest order number).To be able to run from a new IOS image, two possibilities.1) use the boot system flash command to tell the router to use the right IOS image. Be sure that there is...
Hi,From my knowledge, you must configure subinterfaces on the trunk port on the cisco router and configure 802.1q on that port. Vlan number must be the same for both devices (HP and Cisco).Also, you may also configure a native Vlan in the Cisco (Vlan...
Hi Scott,Thank you for your answer. It's an IOS (standalone).By the way, is there some paper explaining how to configure a Cisco AP 1142n ? Further I would like to inprove my knowledge of the configuration of such device.Regards,Christian
Hi,I wonder that you can configure VTP in a router. So far as I know VTP is use to configure VLAN in switches.Usually VLAN are configured in routers with the following commands#vlan xx#int vlan xxTo communicate with switches the interface port must ...
