Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a couple of ASA with some SSM-10 and SSM-20 modules. My CSM is currently not working on the auto update side and i'm a bit behind on the updates till I figure out what's the issue.. Can somebody tell me what link can I manually downoad the s...
Can somebody help provide a config for the nexus 5548 in which it try to look for my 2 ACS servers and then authenticate, authorize and also do the accounting ( logging of commands ) . If the 2 ACS servers cannot be found then it will default to the...
I've got these cables that is connecting between my 6k and 5k chassis. On the 6k it's connected to a 10gig module WS-X6716-10GE runnings72033-advipservicesk9_wan-mz.122-33.SXI5.bin. When I use this cable, SFP-H10GB-CU3M, nothing shows up as connecte...
I'm trying to release a default route learned via OSPF into EIGRP in an ASA running version 8.2.2. my config isrouter eigrp 1redist ospf 1 metric 10000 100 100 100 1500 route-map STATICaccess-list DEFAULT permit 0.0.0.0 0.0.0.0route-map STATIC permi...
I have a strange situation in which I have 2 remote APs running HREAP that will not connect to the primary controller. It keeps going to what I designated to be my secondary controller. Yes, the name and IP address are correct ( double and triple che...
Michael, were you ever able to fix your issue ? Also can you be so kind as to send a snapshot of your RVS4000 vpn configuration. I'm trying to connect to a ASA5510 that has configuration that support a software remote vpn client. I'm trying to use ...
found this link .http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli/sec_tacacsplus.html#wp1272485then all the below mentioned section in ACS either in user account or the group accountworked great
turn out to the cable for the reason. Even thought it looks and feel like the correct cable.. btw, to anybody reading this, there is a command to try too ( didnt' work for me because of the cables ) . service unsupported-transceiver the new cable e...
anybody know the command under the controller CLI where you can manually tell the AP which controller to go to ? Want to give that a shot first.. I did it once but can't remember the command.
