Hello,I have a problem with inter-vlan, on my routage tableCisco1# show ip routeMaximum Parallel Paths: 1 (1 after reset)Codes: C - connected, S - staticS 0.0.0.0/0 [1/1] via 192.168.100.250 0:14:26 vlan 1C 192.168.100.0/24 is...
Hi,I have a problem for config switch sge2000. I can not console mode to get the prompt to type commands. If you could tell me how. Thank you in advance.
I found my problem, it was necessary to connect a PC to a port of vlan.Cisco1# show ip routeMaximum Parallel Paths: 1 (1 after reset)Codes: C - connected, S - staticS 0.0.0.0/0 [1/1] via 192.168.100.250 0:36:56 vlan 1C 192.168.1...
Yes jimmysands, i don't know why my vlan 10 is not present in the routage table. And I would like my vlan communicate with each other via the switch internally.PS: I'm sorry for my english, i'm french ^^