Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a little issue which I can't seem to put my finger on.When my boss initiates a conference call (meet-me) from her extention (7940 ip phone), incoming calls to her extention get added to the meet-me call. How can I prevent this.Call Manager 4...
How can I slow the DTMF signals coming out of a vic2-2fxo. Call manager 4.1, cisco 2801 router, Just switched from AT&T pots (no centrex, no 9) to Time Warner Digital Cable, and it won't dial out.. incoming is fine. No other changes have been made....
I switched local phone service from AT&T (non centrex, no dialing 9) to Time Warner Digital Telephone. Callers are still able to get in, however, I can not dial out. I have a Cisco call manager 4.1, vic2-2FX0 in a 2800 series router. This is a rem...
We recently had a new Call Manager system installed. We have a central office and two remote offices connected via point to point T1s. We must downsize one of the remote offices, and will be getting rid of the T1 for the downsized office, I would n...
Thanks Rob,As far as I know, it has only happened to her. She was on a conference call setup through meet-me, there were 3 other parties who had called in, and her husband called her line directly, and he was added into the meet-me call.She definit...
Resolved!When switching to a service such as Time Warner Digital phone, you must, within the call manager dial pattern, under called party transformations, discard digits: pre dot trailing "#". This fixed my problem and I am up and running 100% but ...
When adding a gateway, My Call manger does not offer H.323.. only MGCP..Am I out of luck? I just signed a 3 year contract for the lines... Is there anything else which could be causing the FXO to not dial out?
