Can somebody help me why my outgoing ftp connection doesn't work. below is my pix firewall config:PIX# show runn: Saved:PIX Version 6.3(4)interface ethernet0 autointerface ethernet1 autonameif ethernet0 outside security0nameif ethernet1 inside securi...
hi, Is it possible to route/forward a call directly from PSTN to 3640 routerA to PBX using voip?network map:PSTN --PRI ISDN-- 3640 routerA(Voip enable) with NM-HDV-T1 card <-- T1 Private Lease Line --> 3640 routerB -- LAN -- PBX(Voip enable(H323))
Can somebody help me? After i upgrade(cisco technical advice) my PIX Version 4. something to PIX Version 6.3(3). I get this error. Finesse Bios V3.3Booting FloppyLoading from Flash######################################################################...
Do 3640(12.2 IOS Enter) with NM-HDV module supports NI-2 with 2B Channel Transfer? If yes, Can you please give me some link/Doc on how to configure?And if not then can somebody give a recommendations? like hardware or any.
Does anybody knows if the NM-HDV-2T1(Cisco 3640) supports 2B Channel Transfer? If does then can you give me a link/sample configuration? And if not then can you tell me what are my options?thanksBAN
below is the sample output from cuteftp:--------------------------STATUS:> Getting listing "/pub/redhat/linux"...STATUS:> Resolving host name ftp.redhat.com...STATUS:> Host name ftp.redhat.com resolved: ip = 209.132.176.30.STATUS:> Connecting...
I remove the "strict" at fix protocol ftp, but no positive out. my outgoing ftp still not working.by the way, I do use this wise-ftp and cuteftp as my ftp client.
I mean that do NM-HDV-2T1(installed in 3640 with 12.2 IOS Ent. and ISDN PRI (NI-2, 2BCT enable) for the telco) supports 2B Channel Transfer (2BCT)? Because I never see any cisco docs(configuration) that talks about 2BCT.this is the only doc that i se...
i think they start at 1, by they way MCI my provider. And the switch they are using is 5ess. By the way how did cisco number the timeslot? and why is it that 23 is the default d channel.
