Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can successfully associate my cisco mobile router with the existing wireless network APs, and the BVI interface can lease the IP from the DHCP server on the wireless network. However, when i connects the client to the mobile router via wired connec...
I have two 3250 mobile routers, and each one has 2 WMICs, 1 MARC and 1 4-port FEMIC. WIC1 seems to be the AP since its FE port connects to the FE0/0 or MARC, and WIC2 seems to be the bridge since its FE0 connects to FEMIC's FE2/3. The IOS version of ...
I have the following situation: I have one internal network with one Class C subnet, and the whole class C subnet is statically translated to the company's global WAN from inside to the WAN interface. Inside has security of 100, and WAN is 0. I newly...
Recently, i am testing something on my newly purchased PIX501. Initially, it comes with PIXOS 6.3.1 and PDM 3.0.1, and i could use the PDM without any problem. However, after i downgrade the PIXOS to 6.1.5 and PDM version to 1.1.2, i could not access...
Recently, we purchased one PIX515E-UR with one FO. During the testing stage, the primary firewall suddenly reboots itself, and the error message is "Nested traceback attempted via interrupt". After rebooting, it just hanged. Even power off and power ...
Finally, i found out the reason. The ip used for the global pool is included in the static translation of the subnets from the inside interface to outside interface. Therefore, PIX can't use this IP as the global ip for another interface, although co...
Actually, i did two testing. One is with PAT and the other is with Static NAT from VPN interface to WAN interface, and the global IP is same. PAT is failed, however, static NAT is succeed.Not sure whether it is the problem with IP-Sec traffic and PAT...
Hi, d-garnett, thanks a lot for your advise. Maybe, i should explain it more clearly. My PIX firewall has 6 interfaces, one Internet DMZ, where the VPN Concentrator connects to, and one Internal DMZ, where the other side of the VPN concentrator conne...
When the firewall boots up, it has the following message "Cannot select private key". Does it mean that i have to create the private key manually, even after i re-enter the activation-key? If i have to do that, what is the command to generate the pri...
Hi, Cihan. Thanks a lot for your care. The issue has not been resolved, and it became worse now. The firewall just rebooted itself during the weekend, and it even could not be manully booted up. The power is on, but all the ethernet ports LEDs are of...
