About Mr. John Doe

Mr. John Doe · 12-06-2017

Good day, I having the following scheme. CUCM<=>VG224 <=> VIC2-FXO4*2921<=>CP7911(SIP) CUCM and VG224 are customer managed, so cannot be debugged or reconfigured. Customer provides 6 analog lines. The problem is that any call coming to voice-port 0...

Mr. John Doe · 12-07-2017

In general, current state of the system is acceptable as these lines are to be used over VSAT link on the vessels as a reserve for two other DID lines from another provider, therefore rare use is expected. Thanks a lot for your help.

Mr. John Doe · 12-07-2017

Will check with HWIC slot change next week as currently cannot get to site.

Mr. John Doe · 12-06-2017

Some update. Situation has not been solved, just got much better than before. About 20-30% of calls are still dropped and this time on all ports.

Mr. John Doe · 12-06-2017

BTW, customer has shared some conf of CUCM and VG, so may be it will be helpful.

Mr. John Doe · 12-06-2017

Sorry for delay, tried as you suggested this morning and everything went fine. voice-port 0/0/2 supervisory disconnect dualtone mid-call no battery-reversal connection plar opx 166077 So, do I need to set it on all ports or there is some hardware...

Member Since	‎10-10-2017 05:33 AM
Date Last Visited	‎12-30-2018 09:16 AM
Posts	8

User Statistics

User Activity

Incoming call to FXO port drop on answer.

Re: Incoming call to FXO port drop on answer.

Re: Incoming call to FXO port drop on answer.

Re: Incoming call to FXO port drop on answer.

Re: Incoming call to FXO port drop on answer.

Re: Incoming call to FXO port drop on answer.