Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I found some article before talked about that we can assigen IP address to router and then telnet to it and configure it , although this router is not configured before , and it based on that the router is connected to switch or another rout...
Dear allI have soho C828-Y6-M with ios 12.2(1)XE1I want to make traffic policing on ethernet interfaceto limit the traffic from one server to 128kis That possible , I tried CAR but it is not supported and also policy map I can't use it for policing c...
Hi all,we have a vpn based mpls network, and I want one of our custome rto use ISDN backup to connect to his vpn in case of failure of the main line (SDSL), the problem is how the isdn line will connect to the vpn and the vrf of the customer, is that...
Hello,I have 2 LANs in different sites , butin the same VPN , I need the users in the 2 LANs to see each other via Microsoft windows neighborhood , and browsing , I think that I need to use helper address , but I want to know which udp portsis used a...
Thanks a lot , but actually I talk about 2 cisco devices switch and router , I need 2 assigen an IP to the router not configured and telnet to it and configure it is that possible by any way , and not using DHCPthanks
To disable HSRP use commands no standby group-no also for the problem , I agree with you that the DL380 may act as a router , so all vlans can talk, we can test with only switches and trunks
To disable HSRP use commands no standby group-no also for the problem , I agree with you that the DL380 may act as a router , so all vlans can talk, we can test with only switches and trunks
if you have IOS eariler than 12.1(6)EA2 , so you need to use the coman managment to enable the managment vlan , if your IOS is later , you don't need to use it , but I thimk there is other command to be used
