Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have a problem with a 3560 switch when we use the function 'mls qos trust dscp'.When we enable this trust command on the interface we reduce the traffic flow to about 4,5 Mbit/s. Regardless if the interface id 10, 100 or gigabit. If we remove t...
Hi,If a spanning tree environment looses its ROOT bridge, a new bridge will be elected. My question is if during this time the switch ports will go through the lis-lrn-fwd states or if the new election is done transparent?(in this case the ROOT bridg...
Hi,I have an AP 1200 that I want to configure in repeater mode, but when I do this it stops to respond to the IP address. Traffic throw the AP works just fine, but I cant access it via IP only buy console.(running ios 12.2.13-JA2)Any Ideas on what i...
Hi,We have configured QoS manually, and don't want to use auto-qos. (it we not work so well with the design)A TAC case will be the next step.Thanks Rikard
Hi,No luck with the upgrade.We have done some test with Chariot, and none of the test gets over 4 Mbit, so it seams to be more then NFS./Regards RIkard
Hi,The Sup II doesn?t support OSPF routing, I thing the only way to overcome this issue is to upgrade to a SUP IV.See this link for more info.http://www.cisco.com/en/US/products/hw/switches/ps4324/products_data_sheet09186a0080197424.html/Regards Rika...
I have redundant links, but the STP root bridge doesn?t have any links there. It is like a ring of switches, and then the root bridge is connected to a switch in the ring but is not taking part in the ring./Regards Rikard