Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
a banner message was created for a switch, when the following started to happen:
When i hit the"c" key on the keyboard in the CLI i get a SF300#% Ambiguous command message
Anyone know how to fix this? The person who created the banner u...
We purchased a SF300. Topology as follows
Cisco 2921 (voice gateway) --->SF300 ---> Juniper SRX
I cannot seem to get the Spanning tree on the SF300 and the Cisco 2921 to recognize each other. I have found posts where it's stated to put the SF300...
Hello Everyone,
It appears to be working using MST on the SF300 to the cisco 2921 using PVST. I don't see any loops etc. I haven't seen any degradation in the network. My CPU values are:
SF300#show cpu utilizationCPU utilization service is on.C...