Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have created a filter with the default action to drop traffic, if there are no rules assigned to the filter Im still able to find UDP ports open through the VPN assigned to the group where the filter is applied. I have even created additional ru...
Hi,I cant seem to create a static nat rule on the concentrator that works, need to create a static nat that all the vpn tunnels could connect to and be translated to an ip that is located on the same lan as the concentrator.Seems easy enough, NAT rul...
Hi,Is it possible for VPN's between spokes to communicate with each other if they are all connected to the central (HUB) concentrator (Star Design) a requirement for a support office to communicate to all our retail outlets but would prefer to create...
Hi,Sorry, should have clarified that the filter is for remote users. If I allow all UDP traffic and perform a UDP scan it shows the UDP ports open of the workstation but when I block all the UDP ports with the filter and then scan, all the UDP ports ...
Would recommend you rather configure the 837 for lan to lan configuration with the pix, I have had no good success cause the easy vpn option is very restricting. If you check under the cisco products and then check with the pix and 837 you will find ...
