Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi NetPro VoIP Guru,Can anyone please kindly explain to me the functions of the following commands?1) network-clock-participate wic 02) voice-card 0 no dspfarmI have done a lot of 2610XM configuration as a Voice Gateway, but not as much for a 281...
Hello,If I connect a Cisco 2821 voice gateway to the following, can you please tell me what cables (Cisco product code) I need to order for the E1 cables? - 2821 (NM-HDV2-2T1/E1) straight to an Alcatel PBX via E1 - 2821 (NM-HDV2-2T1/E1) to Telstra PS...
To all VoIP Gurus,I tried to install CCM 4.1(2) on the MCS 7835 733 server. However, whatever I tried, I couldn't remove the old CCM 3.3. WHen I went into the Control Panel, the Cisco CCM 3.3 is 'dimmed out', so I can't click change / remove.THanks...
Hey guys,I have a generic question of if I need to deploy say 2000 IP phones, what kind of stuff / tools I can use to standardize stuff? Is there any particular thing I need to watch out for / gotcha on large deployment as compared to small number of...
Hi guys,Is there any white papers / instructions on what I need to know in order to integrate traditional PBX into IP telephony? I am a newbie on IP Telephony.Any help would be greatly appreciated.Cheers,L.
Thanks Jasyoung!!!However, since the default payload for G.729 is 20bytes for the payload, if I use:-codec bytes <10> That would be decreasing the payload size, so the bandwidth per call would actually increase while the delay per call will increase...
Hi there,For Cisco IOS Load Balancing, what hardware does it runs on? WOuld normal 3500 works?And if so, do you know where I can find the configuraiton examples on how to setup Cisco IOS Load Balancing?Thanks
