Your right conduit command is deprecated but not until 6.4 so it should work.You have not mentioned anything about your nat configuration. Try adding the following:nat (inside) 1 0.0.0.0 0.0.0.0 0 0This will configure the pix to translate any inside...

Is this a dual sup configuration? If so it can be tricky to move from one major revision to the other in a high availability setup. Due to the fact that the primary sup will force its running version of the os on to the secondary sup in certain sit...

You need to setup static translations and matching conduit statements to allow traffic through a pix.i.e.Port specific static translation statement:static (inside,outside) tcp 8500 192.168.0.5 8500 netmask 255.255.255.255 0 0All protocol static tran...