Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are about to do an upgrade from the 4.0.2(A) version of the client to 4.6. I have created a silent install of the new client and it works just fine. But what I need to do is uninstall the old version then install the new version.Anybody have any i...
Here is my setup:Internet -> Pix -> DMZ InterfaceI have a nat of 10.10.1.10 that nats to 10.20.1.10 (address are just for example)My fw outside interface has a ip of 10.10.1.1 and my dmz interface has a ip of 10.20.1.1. From my workstation at work I ...
I would suggest trying to upgrade to a newer version of IOS.In the intermin trying uppping the arp timeout on the ports the printers are attached to.Like if the printer was attached to FastEthernet0/1config tint fa0/1arp timeout 2147483
So there is not any support for Source Address translation? I know in the FW-1 world you can do a 'NAT Hide' behind the inside interface. Which is a wonderfull solution to solve lan routing issues.I would want it to look like this.Internet IP -> Dest...
