Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am tracing a OSPF Point-To-Multipoint Non-Broadcast connection. The neighbor state goes to Full but I noticed there is no Designated Router Elected. I though there was always a designated router elected. Do we not need one?
What is the difference between the following:"ip ospf network non-broadcast" and"ip ospf network point-to-multipoint - non-broadcast"-Are there any differences in the OSPF exchanges?Can you specify point-to-multipoint non-br...
I took a CISCO SNA class several years ago. There was a section on DSPU which i recently reviewed. There have been additional features and options added since I took that class. I saw some examples that use the "SNA HOST" configuration command. Can s...
I just configured SNASW to connect a PU to EE on the M/F. If the SWNET is not active on the M/F, the cisco console log fills up with event messages. Is there anyway to filter or disable these SNASW activation attempt logging messages. Every 30 second...
Thanks for responding. I have a special case situation. I have TCPACCESS IP Stack running GATED on a Channel attached Processor (CIP). We normally specify IP OSPF Non-Broadcast (NBMA). We specify Neighbor statements and everthing works fine. I saw th...
Thank you for your input and suggestions. There does not seem to be a good solution to this situation. I think adding an option to disable messages would be reasonable. If the link is broken the CISCO technician will be investigating the SNASW status...
Normally the SWNET member would be active. They IPL'd Saturday night and the member was not in the auto start list. It has since been added. When I came in Monday A.M. the log was full. It would be nice to have more control of which messages go to t...
I finally got this working with SNASW and TN3270-Server. It uses HPR on the M/F. The TokenRing XCA is not active on the M/F. I needed the TN3270-SERVER PU so I could create an LU session through SNASW (enterprise ectender). Thanks for your help. sour...
